As many know how to optimize overwatch on the console is being a problem I've been through the forum several times trying to fix this crosshair problem at low sensitivities
So researching a bit more about the "double zone" and "exponential increase"(Located in options-> controls-> under sensitivity-> advanced)
I discovered that in "double zone",Below 10% strength, the analogy behaves like a mice.
Then I opened the reasnow software on my computer, and on the right stick, I clicked on it, there appeared more options, below there is an option called "Strength Percentage".
I thought of the following, if I put a maximum percentage of force, for my analog, at 10% and increase my ADS and HIP, I'll have a mice with the highest possible aim control, both low and high sensitivity, without that problem to "skiping pixel in lower sensitivity".
The Problem is:
When I put in the space of "Strength Percentage", 9%~10%, and I go on the test console has no effect at all.
So I put a key in the space, "capslock", so when I press this key, it changes the strength of my mouse to 10%, when I went to test on the console even pressing and holding does not have any effect.
As my english is very bad, I tried to explain without getting so confused I hope you guys compliment my research goal.
What did you think ? I would like suggestions to try to set my maximum strength in the mice by 10%
My goal is to lock my mice in 10% strength, so when I do more strength than normal inside the game does not increase the sensitivity and the accelerator
